Windows 10 sleep vs hibernate12/29/2023 ![]() As noted above, when a block is written to, the entire block must be erased before it can be used to store new data. The TRIM command solves a performance problem that eventually crops up in SSDs over the course of continued use. Stop the service and set the ‘Startup type’ drop-down menu to Disabled.īonus tip: optimizing performance with TRIM That’s a no-no! Disable it by searching for “services.msc” in the Start Menu search boxįind and right-click Windows Search to open the properties. The search indexer made searching for files on a traditional hard drive speedier, but it doesn’t do much on an SSD except perform small writes. If you have hard disks that would benefit from a good defragging, you can run the defragmenter on a schedule for those particular disks. To turn off your disk defragmenter, uncheck the Run on a schedule box in the defragmenter program. You should defrag only your non-SSD drives. In fact, defragging makes numerous small, unnecessary, device-killing writes to the SSD-reason enough to eliminate it from your routine. Because there is no moving read-write head, and because of the nature of flash memory and controllers, fragmentation as you understand it does not exist with SSDs. First check to see if this option isĪvailable on your PC and if it is, turn it on.First and foremost, your days of worrying about fragmented files are over. Use hibernation when you know that you won't use your laptop or tabletįor an extended period and won't have an opportunity to charge theīattery during that time. (For example, PCs with InstantGo don't have the hibernate option.) Hibernate uses less power than sleep and when you start up the PC again, you’re back to where you left off (though not as fast as sleep). This option was designed for laptops and might not be available for all PCs. Use sleep when you’re going to be away from your PC for just a little while-like when you’re taking a coffee break. You don’t have to worry that you'll lose your work because of your battery draining, because Windows automatically saves all your work and turns off the PC if the battery is too low. ![]() This uses very little power, your PC starts up faster, and you’re instantly back to where you left off. Note that OLD PCs don't have a hibernate option. Now you'll be able to happily hibernate your PC. Under Shutdown settings, select the Hibernate checkbox (if it's available), and then select Save changes.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |